KF316C10B/8 8GB 1G x 64-Bit DDR3-1600 CL10 240-Pin DIMM Continued >> FEATURES FURY KF316C10B/8 is a 1G x 64-bit (8GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 2Rx8. memory module. based on sixteen 512M x 8-bit FBGA components per module. Each module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below. Each 240-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows: CL(IDD) Row Cycle Time (tRCmin) Refresh to Active/Refresh Command Time (tRFCmin) Row Active Time (tRASmin) UL Rating Operating Temperature Storage Temperature 10 cycles 48.125ns(min.) 260ns(min.) 37.5ns(min.) 94 V - 0 0o C to +85o C -55o C to +100o C FACTORY TIMING PARAMETERS • Default (Plug N Play): DDR3-1600 CL10-10-10 @ 1.5V DDR3-1333 CL9-9-9 @ 1.5V DDR3-1066 CL7-7-7 @ 1.5V • JEDEC standard 1.5V Power Supply • VDDQ = 1.5V • 800MHz fCK for 1600Mb/sec/pin • 8 independent internal bank • Programmable CAS Latency: 11. 10. 9. 8. 7. 6 • Programmable Additive Latency: 0. CL - 2. or CL - 1 clock • 8-bit pre-fetch • Burst Length: 8 (Interleave without any limit. sequential with starting address “000” only). 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] • Bi-directional Differential Data Strobe • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) • On Die Termination using ODT pin • Average Refresh Period 7.8us at lower than TCASE 85°C. 3.9us at 85°C < TCASE < 95°C • Asynchronous Reset • Height 1.338” (34mm) w/heatsink Document No. 4810128A 07/12/21 Page 1 kingston.com Memory Module Specifications Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS. MODULE DIMENSIONS MODULE WITH HEAT SPREADER continued All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published FURY memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components. https://www.kingston.com/dataSheets/KF316C10B_8.pdf